You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Next »

In einem Time Series Chart können Sie auf zwei Arten Filtern. In der ersten Methoden klicken Sie auf den gewünschten Startpunkt und ziehen die Maus zum gewünschten Endpunkt (die Maus bleibt währenddessen gedrückt). Auf diese Art und Weise können Sie viele Datenpunkte auf einmal als Filterbasis auswählen. Abbildung 17 zeigt ein Beispiel dafür, wie das Diagramm aussehen sollte direkt bevor Sie die Maus loslassen. Eine weitere Möglichkeit besteht darin, einfach auf einen der Datenpunkte auf der Linie zu klicken. Wenn es mehr als eine Aggregation gibt, bedeutet das Klicken auf einen Datenpunkt jedoch nicht, dass nur die zugehörige Aggregation für den Filter ausgewählt wird. Vielmehr werden durch das Klicken auf einen Datenpunkt in irgendeiner der Linien alle Aggregationen an dieser Stelle als Filterbasis ausgewählt (d.h. wenn Sie auf einen der Datenpunkte bei „January 2013“ inAbbildung 17 klicken, wird „January 2013“ als Filterbasis ausgewählt). Wurde der Filter angewendet, erscheint der übliche „Auswahl zurücksetzen“ Button über dem Diagramm.
Information des Time Series Chart

Time Series Charts können verwendet werden, um eine oder mehrere Aggregationen zu einer einzelnen Dimension anzuzeigen (siehe Abbildung 2.12) . Im Gegensatz zu Liniendiagrammen (Line Charts) sollte jedoch eine Zeitdimension verwendet werden, da Time Series Charts für diese Anwendung optimiert wurden. In einem Time Series Chart wird die x-Achse dynamisch so formatiert, dass die Übersichtlichkeit auch für Zeitdimensionen mit hoher Granularität erhalten wird.

Abbildung 2.12: Time Series Chart

Interaction mit dem Time Series Chart

In a Time Series Chart, filtering can be done in two ways. One way is to click on a desired starting point and holding the mouse button pressed down while moving to the desired end point. That way, multiple data points can be selected as filtering basis. Figure 2.13 shows an example of what the chart should look like directly before releasing the mouse button. The other way is to simply click on one of the data points on the lines in the line chart. However, if there is more than one aggregation, clicking on one line in the chart does not mean that only data of this line will be selected in the filter. Rather, by clicking on one data point in any of the lines, the associated data on the x-axis is defined as filtering basis and all points of aggregated data belonging to that data will be selected (e.g. if we click on one of the data points at "January 2013" in Figure 2.13, “January 2013” will be selected as basis for the filter). Once the filter has been applied, the usual “Revert Selection” option will appear on top of the chart and allow you to reverse its effects.

Figure 2.13: Time Series Chart - Filtering

As can be seen in Figure 2.12, a legend at the bottom of the chart shows the different lines of aggregated data. By clicking on one of the legend entries, it is possible to hide single lines from the chart. If a line is in hidden mode, its respective legend entry will be greyed out and the line will not be shown at all. Clicking its legend entry again will make the line reappear.

If export was allowed during the configuration of the Time Series Chart, the data providing the basis for the chart can be exported in View-Mode. In that case, a small disk icon () will appear on top of the chart. Clicking on it will lead to a download of the chart’s content as an xlsx file.

  • No labels